This job was really about servicing the remote
preload unit. On my rides I have been fiddling about the preload to get a
comfy ride and improve cornering. This bike tends to wash out in
corners and on roundabouts. There is no adjustment on the front
suspension. There are few suspension settings to adjust on the rear
suspension unit, just preload and rebound damping. My wife and I are
probably in the middle weight range, even a bit lighter than the
expected Pan riders, so the spring rate should not be an issue. There
is nothing I can do about the spring rate rebound or the damping except
adjust the screw. The preload adjuster is a different matter. A little
bit of internet research showed the preload unit was prone to loosing
fluid and so the ability to adjust the preload on the shock. Click HERE
to check out this Youtube video for the details on how to asses if the
preload adjuster needs attention and how to go about the job. You need
the seats removed but not the fairing just the nearside side panel. You
don't many tools. A 10mm socket, a Phillips screw drive and a pointy
probe. It is not clear in the videos but you top up the unit with fork
oil. I happened to have 10 weight oil left over from the front
suspension overhaul.
I removed the side panel and the two 10mm bolts hold the adjuster unit
to the support bracket. My unit was at least as bad, and probably worse
than the unit in the video. I was most concerned I might loose the the
spring loaded ball bearing. In the end I managed the ball quite easily
as the spring and ball where gummed with dirt in the old grease.
As per the video I removed the unit and tipped out the
oil. Oil, well, there was a bit. The black bits are from under the screw
knob.I did as instructed and flushed out the unit. As the video guy
suggested I marked the banjo bolt and preload unit before starting and
it was helpful in being able to reposition and refit the unit on to the
preload support bracket. Whilst I had the unit in bits I cleaned and
refurbished all the parts that were accessible. I had been a bit over
enthusiastic with the rattle can so I spent a few minutes with 1500
grade paper sanding off over spray from the preload unit. the unit was refilled with 10 weight suspension oil.
Once
the preload was refitted one could feel the resistance of the oil with
one and half turns of the adjuster knob. I also checked the rebound
adjuster screw for free movement. I am pleased to report it works
perfectly. The side panel was refitted.
The next job will to go for a spin and adjust the preload the damping to suit me.