The bike went through its annual MOT
(Ministry of Transport) test for roadworthiness as a pass an with no
advisories. Advisories being little jobs that need addressing to bring
the bike up to MOT standard but not serious enough to constitute a
danger to the safety of the vehicle. The testing bloke commented that
the bike was a nice example of the marque and in really good order. That
was nice to hear given the light restoration I had given it over the
winter. He mentioned the action of the clutch lever in passing. I had
noticed the bite of the clutch took a little getting used to. I
remembered I had topping up the brake fluid in the reservoir as a job to
do. The fluid was just above the minimum marker. The screws in the
reservoir cap were really tight so I put it to the bottom the list as
the clutch was working just fine. Now I thought I would do that top up
job.
I
very carefully drilled out the head of the screw to leave just the
thread portion of the screw in position. I had to be very careful. The reservoir cap and body the body of the master cylinder is made from a
magnesium alloy which is much softer than the steel of the set screw.
One slip could damage the cap or body. That would mean a new master
cylinder, the sourcing of which would cost time and money. So far this
job had cost £3.80. Patience paid off. As soon as the heads where
drilled out the reservoir cap came away undamaged. The screw threads
were still in the reservoir body. With some trepidation I turned the
remainder of the screw with my fingers. The thread turned easily and
were removed in seconds to my great relief. I was not happy
contemplating stud extraction for the master cylinder body. The fluid in
the reservoir look really dirty. I guess it has been in there since the
bike was built in the factory. I used a syringe to remove most of it
and topped up the reservoir with fresh clutch/brake fluid. The oil seals
and space was cleaned and refitted. The reservoir cap was cleaned and
checked that the new screws would seat in the cap. There was a lot of
corrosion at the base of the set screw as it went into the master
cylinder body. That was what was preventing the screw coming out. I put a
smear of copper slip grease on the underside of the set screw before
refitting it through the cap. The screw seated nicely. So that job was
done. Whilst I was about ti replaced the screws in the front brake
master cylinder. These screws came out with much effort. The new screws
were copper greased and refitted. The work of a few minutes.
