The Pan has a hydraulic actuated
clutch. "So what" I hear you say. The MOT bloke said the clutch had a
funny bite as he had to move it around the garage. I too though the
operation of the clutch was a little strange. Not enough to be worrisome
just "not so". The Pan was registered in 2004. I suspect the clutch
fluid has never been changed. Brake and clutch fluid (they are the same
thing) absorb water over time and the fluid regrades. The hydraulic
system can loose fluid or gain air from microscopic leaks. The fact the
the clutch master cylinder reservoir cap screws were was seized backs up
that theory. Click HERE to read the blog on replacing the screws in the clutch master cylinder.
Changing the clutch fluid should not be that difficult; I had replaced
the reservoir screws so they came out without and hitch. So long as can
find where the bleed nipple for the slave cylinder is situated. I tend
not to look in the owner's manual any more but go straight to YouTube.
There is some proper crap there but there is usually a nugget of gold in
the videos. This link, click HERE,
takes you to the chap who gave me a clue as to where the clutch slave
cylinder bleed nipple was sited and whether is was an easy job. I had a
feeling the bleed nipple would be hidden behind the faring somewhere. It
seemed sensible to tackle the job whilst I had the belly pan off as
part of the wiring upgrade for the Sat Nav and the USBs.

The clutch bleed nipple is located on the near side just behind the
bottom of the coolant expansion tank. It is easy to get to once the
belly pan is removed. In the picture you can see I have a 10mm ring
spanner on the bleed nipple and the tube leading down the catch bottle.
Bleeding the clutch is just the same as bleeding brakes. With the nipple
closed, pump the lever the build up pressure in the line. Undo the
nipple, the pressure in the line is released and the air, if air is
trapped, is released after a few cycles od pump and release. In my case I
simply wanted to replace the fluid. with each pump and release a
quantity of old fluid was pumped out of the system. After five or six
cycles the master reservoir was running low on fluid so that was topped
up. The topping up is down to ensure air is not introduced from in to
the system from the top. The pump, release and top up cycle is continued
until the fluid being pumped out at the bottom is clear like the fluid
introduce to the top of the system. The master cylinder reservoir cap is
refitted.
Although
I did not ride the bike straight away I could tell the replacing of
the clutch fluid had had an effect. There was a lot less free movement
in the lever and it felt firmer. I do not anticipate any operational
difficulties.
NB...
make sure in all this exercise you protect the paintwork from drips of clutch fluid. It will eat your paint for breakfast.
I had one other job to do then the belly pan was refitted.