This post should where has the power gone! When the fairing was
refitted, the USBs were connected up. It was a real treat to see them
work first time. The USB with voltmeter was particularly good. I turned
the bike off and left it until the next time I was able to do some more
fettling.
At
the next visit I turned the ignition to be greeted with the sound of
relays clicking and dull dashboard lights. I looked at he voltmeter and
it was showing 9 volts. It occurred to me that the LEDs on the USBs had
run down the battery over a week. I connected the battery charger and
went away to think about the situation. I decided to test the hypothesis. Once the battery was showing recharged I pulled the fused
for the USBs and sat back to see what would happen. I went back to the
bile a few days later, using a multimeter i tested the voltage of the
battery. It had dropped again but not quite as far. The new fuse box has
LEDs to show when a fuse has blown. It was with some frustration I
disconnected the power feed from the battery to the fuse board. The
charger was reconnected. The voltage was checked after a few days. No
loss of power and the bike would start on the button. Now what?
It took a few minutes for the issue to percolate in my bonce but the
action was clear. I need to switch off the fuse board when it is not
needed. I could wire a switch into the heavy duty power feed so the
solution had to involve and relay. I had a suitable relay in the tool
box. I changed the post terminal tag connect to the live feed wire from
the battery to a spade connector. That connector went on the replay. I
made a jump wire with a post connector one end of the 27amp wire and a
spade on the other end. Now I had a relay in between the battery and the
fuse board. The wiring was checked with the multimeter. there was no
current getting the fuse board. I put two spade connectors on the wires
of a twin cable and connected them to the switch side of the relay. I
stripped the wires at the other end of the cable and touched them off
the battery. The relay and fuse board reacted when power was applied to
the switch wires. So that works.
The relay needs somewhere to live. Luckily the battery box has a
handy size void at the rear of the box which forms part of the rear
inner mudguard. It was a simple job to drill a hole through the
mudguard, its plastic, and use a plastic number plate nut and bolt to
secure the relay to the mudguard. I had measured the jump wire to allow
the relay to be fitted in the void.
The only problem is that I now have to decide where the switch is to
be fitted and what type of switch to use. Then I have to buy it. Then
fit it.
I had a suspicion the battery would not be capable of sustaining so
many warning lights. the battery is tiny compared with that of a BMW
which is essentially a small car battery rather than a standard bike
battery on the pan. The difference is clear but now I have resolved the
issue.