The fork legs were set aside after fitting new seals but not for long. Click HERE
to read about the fork seal replacement. I washed the sliders down with
degreaser, then rinsed with water. When they were dry I rubbed them
down with emery cloth to remove any rough patches. The intention is not
to polish the sliders but to provide a key for the paint. I masked up
the new seals and chrome stanchion. Then a can of gloss spray enamel
paint was sprayed on in thin coats over a few days. The result is smooth
and shiny. That should prevent the road dirt sticking and make
cleaning easier.
The rattle can got a shake up and thin coats of enamel were sprayed onto the carriers avoiding the moving elements. With the calipers drying the brake pads were cleaned with brake cleaner and a toothbrush. In due course the pads were fitted to the caliper. A little copper grease was applied to the end of the pad securing pins. The front end was now ready to be reassembled.
There is a left and right fork. The dirt deflector was fitted to the top of each slider. Each leg was identified and slide through the bottom yoke and in to the top yoke. The top edge of the stanchion was lined up with the top face of the yoke and the pinch bolts tightened. In the interim the front wheel fender had been cleaned, inside and out. New clips had been fit where necessary. The fender was offered in to its place. a couple of bolts were gently fitted. The front wheel was refitted but the spindle was not completely tightened. The brake assemblies for each leg were refitted ensuring free movement where required and secured where required. The brackets for the brake lines were secured. The remaining bolts were fitted to the fender and the whole finally tightened up. The wheel was spun to ensure it moved freely....It did!
