Having ridden the Pan for nearly a year it seemed to me the handlebars
were just a bit far away from me. With that I did not feel completely
in control. I knew from forums there were such things as handlebar
risers. The risers raise the bars a little and moves them back a little.
Luckily it did not require the wires and cables need to be extended.
Brand new risers are somewhere around £180 to £230. I was luck to find a
second hand unit for half the price of new ones.
![]() |
| Middle item is the handle bar damping plate |
As with other parts of the bike there was a fair bit of corrosion
keeping the nuts and bolts which is probably you want with
handlebars. Fortunately I had sourced the riser before I started the job
and the plan was always to tackle the risers whilst the forks were out
of the bike. Even with the fairing removed it was still a tricky job. I
was unfamiliar with the handlebar fitting. It turned out the handlebars
are connect directly to the upper fork yoke. Some BMWs I have this
feature. The feature lessens the road vibration to the grips. The handlebars and decorative cover came off quite quickly, first having
been careful to use lots of penetrating oil so as not to strip the heads
of the nuts. Drilling out the bolts was to much to contemplate. The
handlebars off the damper was visible however the bolts to secure it
were under the top yoke. Even with the fairing and forks out of the way
it was fiddly to remove the nuts. Once all the original parts were
removed I cleaned and polished the top yoke.

The new riser was put in place. You can see in the picture (left) the
riser partly obscures the top the fork leg. This meant I would not fit
the risers and handlebars until I had replaced the refurbished fork legs
back in place. Fast forward to the fork legs having been fitted. The
large bolts that secured the original damping plate fitted straight back
through the new riser and were secured with the same set of rubber
washers, metal washers, spring washers and nuts, all done upside down
were you cannot properly see what you are doing.
The last job was to secure the three bolts in each handle bar arm
and fit the centre cover. Part of the reason for getting the risers was
to have a place to put the sat nav (when I get one). Another job closer
to the MOT.

