I installed two USB units, one in each fairing pocket and there is
controller for the heated grips. The fairings will have to come off
again in the future. So I thought worthwhile in investing time to fit
electrical connector plugs to make that job easier and it would look
smart. The plugs would lead back to a fused distribution board. The
fused board would take a feed directly from the battery and let me add
more equipment in the future without overloading the factory fit
electrical system.
I decided to tackle the complicated connection first. First up the heated grips controller. To make this a trial I could not find a wiring diagram
for the grip and switch. The grips have three settings. off, warm and
hot. I had the presence of mind to take a photo of the original
connectors for reference. The live feed had been bodged of the switched
wiring loom. I was able to cut the wire back, removing the bodgery. I
slipped the heat shrink sleeve over the wire. I stripped back the old
wire and the end of the new wire. They were twisted together and
soldered. When cool the heat shrink was put in place and heated with hot
air. The join is properly secure and weatherproof.
The earth wire was quite short. I remove the ring connector bolted
through to a fairing bracket. I got a new ring connector a crimped,
soldered and heat sleeved to the new length of wire. I went very
steadily whilst I worked out now the make the connections into the plug
blocks. The first block I tackled, for the heated grips, needed jumpers
as well. After a false start the grip heated on demand. I used a little
building mastic to weatherproof the back of the blocks.
Once I had tackled the heated grips x6 plug it was a much more straight
forward affair to organise x2 plugs for the two USBs. The extra work
that took time was routing the power cable from the tail unit to the
USBs in each fairing pockets. I used plenty of heat shrink and mastic.
The back of the USBs are in a vulnerable place inside the fairing.
See blog the about the accessory power panel click HERE
See blog the about the fitting the USB units click HERE

