I had tackled the headers whilst I was dealing with the clean and paint of the engine after the service, Click HERE
to read about that. The silencers had both been taken off at an early
stage and parked up at the back of the garage. They where not in bad
shape. a scratch here and there and just a bit grubby. They where quite
clean because you can get at them easily so general cleaning is not a
problem.
It
had occurred to me that once I broke the seals on the exhausts they
would probably not be reusable. The OEM exhaust clamps where it bit
tired. I figured I would probably break them as I removed them and so I
got a set of exhaust gaskets and stainless steel clamps.
It took a bit of fiddling to get the graphite gaskets off the pipes.
As expected they were destroyed in the process. I used wire wool to
clean up the are where the gasket had been.
The jobs was simply enough. Wash the the dirt off. Use Gunk degreaser
for the heavy stuff, rinse with hot water. They where better but to
finish them off toothbrush and Autosol (click HERE
for website). The Autosol and elbow grease did a good of removing the
baked on grime. The photo does not begin to do the job justice.
The silencers were returned to their corner of the garage until they
were ready to refit to the bike. Fitting them to the bike was a doddle.
The gaskets slipped on snugly, I was very careful with them. I
remembered to slip the clamps over the pipe before joining up the
silencer to the header collector pipe. The mounting bolts went straight in, with a dab of copper slip to help get them out if they ever
come off again. The clamps were nipped up. Later when the bike was run
there were no leaks fro the exhaust.