
This painting element has been a bit of a creeping project. To begin
with I thought I would spruce up the crash bars because they had a bit
of rust on them. A wash and rub over with the spinning wire brush, they
looked quite good after a can of paint had been spray over them in a
series of coats over a week.
Then I decided that a colour change was in order. I would have preferred
a white Pan but a silver version is what came my way. I have discovered
that many Pan owners have issues with the finish on the castings which
make it tricky to keep shiny. With that in mind I decided upon a course
of action. The silver body panels and major frames elements would
remain silver but the engine, forks and swing arm would be painted
black. The wheels are already black. The look will be two tone. The tops
silver and the bottom black. This was only decided upon after I had
painted the crash bars and the front of the engine.
Whilst I had the body panels off I gave everything a good wash, first
with engine degreaser (Jizer) then a power wash. When all was dry I was
going to hit the engine with a wire brush. I had done the front of the
engine but a problem occurred....the exhaust headers were in the way. I
oiled up the jubilee clips connecting the headers to the exhaust
silencers. The silencers came off much easier than I expected. I soaked
the header bolts in oil and after a few days they came off without
damaging anything. There is always the threat the bolts or nuts will
strip or damage the threads. The repair is always expensive in time,
money and is often a less than perfect repair. Replacement header and
silencer gaskets were orders and was stainless steel silencer clips to
replace one OEM versions which after 15 years were looking a bit tired.
The big round wire brush took care of the flatter areas of the engine
body and the small pointy wire brush took care of the tight spaces and
webbing. A wipe down to remove the dust, a spot of heath Robinson
masking and it was time to get the rattle cans busy. I bought high temperature gloss black paint. Two full cans were applied in coat to the
exposed engine. Once dry the the surface of the casing was smooth with
paint. It should be much easier to keep clean and it should stop the
alloy casing corroding any further. It looks smart too!
It was a fiddly job to fit the new header gaskets but once the first
one was positioned and the nuts started on the studs it was an easier
job the fit the other three. The exhaust header nuts were tightened up.
The next job was to refit the radiator. See Return of the Radiator.
The crash bars were refitted. The refurbished fork legs had been set
aside and now it was their turn in the makeshift spray booth for some
rattle can action. Another can of paint was applied in thin layers. The
finish is smooth. They should not hold the road dirt as much as the
standard finish. Any brake lines and brackets got the paint treatment at
the same time and for the same reason. When the paint was dry the forks
were fitted back onto the bike.
Whilst I was at it I went through the same cleaning and paint process on the side sand and main stand.