Getting the radiator back from the firm that repaired the radiator was a
bit of a trial. They were located about 25 miles from me so I was able
to "pop over" and have a word. I finally got the radiator back after
three weeks. The repair firm had got hold of a curved core. They then
tried to mate it to the existing headers at each end of the core. They
headers were shot. The Aluminium had corroded to a state were they would
not weld. Sam, the technician, who was doing the work set about
fabricating and pair of headers. The manufacturers headers are usually
quite flimsy pressed Aluminium. Sam made a set from plate Aluminium. As
it was plate it is much thicker, which I guess makes it easier to weld.
The welding is not machine quality but I do not mind. It is hand made.

On the appointed day of collection I went over the Wednesbury only
to find the radiator was not quite finished. I had to kick stones for a
few hours. On my return the radiator was ready, paint still tacky.
The next job was to refit the radiator back on the bike. It was then a
noticed that Sam had made brackets to replace the corroded items on the
original radiator. First job was to refit the fans to the back of the
radiator. Stainless steel clip replaced the originals. The left fan went
straight on. The right fan did not quite locate onto one of the
brackets. Twenty minutes of careful drilling and filing and the bolt
lined up. The lick of spray paint to protect the new cut surfaces,
replacement clips and the radiator was ready to be refitted. The bolts
that retained the radiator were a but rusty. I gave the a brush with the
wire brush and spray of paint and they too were ready for the refit. I
offered the radiator up and refitted the bolt through the top brackets.
The side brackets located smoothly. Well done Sam.
One of the my rebuild rules is that any refitted bolts get a cleaning
and a dab of Copper grease upon refitting. Depending on the situation
the fitted nuts get a slavering of ordinary grease. That should keep the
weather off for some time. The hose spigots lined up perfectly which
made refitting the hoses a doddle. I replaced the original hose clamps
with a stainless steel option. The electrical plugs for the fans were
reconnected and secured to their respective brackets. The header tank
was refitted to its off side position and topped up with premixed
coolant. The radiator was filled with Putoline NF premixed coolant.
Running the engine up to temperature to vent the system would have to wait until I refitted the front wheel and suspension.
Putoline NF coolant Volume = 2.5 litres including header tank.
If you need your radiator re-cored you could do a lot worse than West Mercia Radiators. They are a bit chaotic but I suspect that is because they in demand. They honoured the price they quoted even though did extra work fabrication the headers.
