Sunday, April 11, 2021

Charger leads

 I have a a splendid charger from Optimate. They come with a plug and lead that you can attach to your bike's battery. When you need a charge you plug the charger into the bike. However I have two bikes that need charging but only one lead. No probs, look up the Optimate website, find my charger model and order a lead....er no....discontinued. I did not fancy forking out ninety quid for a replacement charger with multiple leads in the new format. 

 

 

  So easy enough. Make up a news leads with compatible plugs. I had a tray of suitable plugs from the other wiring jobs. The Pan had a lead but with the obsolete plug style. I did not replace the side panels when I replaced the battery as the problem was evident as soon as I put the battery on to charge.

 

    I could swap out the obsolete plug whilst is was attached the a live battery. SO the lead was take of the bike. It also made the job easier. I decide the male plug would go on the charger and female plugs on the bike.

 

    To make sure I did not cock up I started with the male plug on the charger lead. The charger lead was very long so I was able to cut off a length to make the bike side lead for the Yamaha.  I had a good deal of practice making plugs when I did the wiring on the Pan for the power sockets so it was just a case of working through the process. The key thing was to make sure the polarity was correct, especially as all the wires were black. 

   The lead for the Yamaha needed terminal rings as well. As luck would have it there were just two in a electrical bits a bobs box. A bit a shrink wrap to tidy up the ends and the that part of the job was done.

The last part was to attach the leads to the batteries on each bike and test the charger. If the polarity was wrong the charger would not work. As it was the charger indicator lights lit up as they are supposed to. Now I can plug the charger into either bike as required.